Installation guide

[TrA-I CUTOUT FOR SINGLE OVENS IN WALL CABINET
NOTE: If the cabinet does not have a front frame and the sides are less than sA" (1.9 cm) thick, shim
both sides equally to establish the cutout width.
These ovens
are not
approved for
stackable
installations.
i .....
m-J
!F
;I
]
Opening
BetweenInside
Walls Mustbe
at Least287"
(72.4cm)Wi(Je
a Junction
Box
Location
Ijunction
', box may
be located
i
', ' 22" (55.9
Ii cm} Min.to
|_ _ Bottomof
' Junction
Center Line
I
P
Cutout
observe all
dimensions ond
requirements.
Side-by-SideInstallations
Install two ovens in separate cutouts.
Center Line
30" Models
q 87/(148.6 cm} ifboth ovensore FrenchDoor
42_" (108 cm)if onlyoneoven is FrenchDoor
I
I
Cutout
observeoil
dimensionsand
requirements
=====-li_l,,I-,_;.-,_.30" (76.2cm) Min.if both ovensore FrenchDoor
14" (35.6cm) Min.if onlyoneoven isFrenchDoor
Dimension Dimension Description
A Cabinet width
B Cutout width
C Cutout height
D==€
_=-=-B -==-_
C
G
t "
Recommended
Cutout Locationfrom
Floor
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
....ii............ii!!i i!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii ;,,,,,......
..............................................
30" Single Oven
30" (76.2 cm)
28_/_" (72.4 cm) min.
28_" (72.7 cm) max.
27_/_" (69.2 cm) min.
27_" {69.4 cm) max.
D Overlap of oven over side edges of cutout _V_" (1.75 cm)
E Door swing depth - Allow additional clearances for 16V_"{41.3 cm) min.
installation and oven usage
F Overlap of oven top of cutout 1" {2.5 cm) min.
G Overlap of oven bottom of cutout lye" (3.2 cm)
J
K
L
Junction box location
Door swing width - Allow additional clearances for
installation and oven usage
Countertop or cabinet door protrusion Imeasure if exist)
Gap between edge of countertop or cabinet door
to cabinet opening
9_/_" (24.2 cm) max.
right side only
14" (55.6 cm) min.
Measure "K"
If K = 0, L = 0, Otherwise
L = K + 2" (2.54 cm) min.
121BICUTOUT FOR INSTALLATION OVER A WARMING DRAWER
NOTE: Install the oven only with specific models listed on the label located on top of the oven.
NOTE: Additional clearances between cutouts may be required. Check to be sure the oven supports
above the Warming Drawer location do not obstruct the required interior depth and height.
When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ, properly
grounded receptacle must be installed. Refer to installation instructions packed with
the Warming Drawer for specific installation requirements.
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement N
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement