Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT save these instructions for local inspector's use. IMPORTANT — observe ai governing codes and ordinances. » Note to Installer — Be sure to leave these instructions with the Consumer. + Note to Consumer — Keep these instructions with your Owner's Manual for future reference. « Skill Level — installation of this appliance requires basic mechanical and electrical skills « Completion Time — 1 Hour.
Design Information PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model.
Installation Preparation ELECTRICAL REQUIREMENTS Single Vanadium 120 Installation: This product requires a 120-volt, 60 He, 15-amp circuit ond draws 1.8 kilowatts. This product must be connected to a supply circuit of the proper voltage and frequency. « Wire size must conform to the requirements of the National Electrical Code or the prevailing local code for this kilowatt rating = The power supply cord and plug should be brought to a separate 15 or 20 ampere branch circuit single grounded receptacle.
Installation Preparation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING The Vanadium 120V can be installed in combination with other GE/Monogram appliances. Always follow each product's Installation instructions to complete the installation. Single Vanadium 120V Installation: Order a 30" wide single oven cabinet or cut the opening in a wall to the dimensions shown. 307 23-fee" Construct Use ~] Min 3/8" .
Installation Preparation reparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING (cont) installation over a GE/Monogram oven: 30" 23-142" a 8 Construct Solid Bottom Min. 3/8" Plywood Supported by C2xbdor2xre Runners all Four Sides ~2" Min. 3 4 {3 Recommended) Per Oven Requirement VY « If you are replacing a Monogrammed electric double oven with the combined installation of an Vanadium 120V and o single oven, use the dimensions shown.
Installation Preparation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING (cont. Installation over another GE/Monogram Under-the-Counter (UTC) over: 30% 23-142" Construct Solid Boston Min. 3/8" Plywood we 25-187 | Supported by nf 2x GOT 202 “1 Runners all ya Four Sides pa 2" Min. pe i (3" Recommended} « If you are mounting an Under-the-Counter GE/Monogram oven over another, use the dimensions shown.
Installation Preparation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING {cont} installation beside another GE/Monogram el) Built-in Speed cook Oven: « If you are mounting one Under-the-Counter GE/Monogram oven beside the other, use the dimensions shown.
Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL 25C1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE MODEL 25C1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING {cont.} The Vanadium 120V can be installed in combination with other Monogrammed appliances. always follow each product's Installation instructions to complete the installation.
Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL 25C1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE MODEL 25C1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (cont.} installation over a Monogrammed Oven: 307 = Construct Solid Bottom Min. 3/8" Plywood Supported by 2xbor2xe Runners alt Four Sides 27 Min.
Installation Preparation Preparation WITH an Accessory Storage Drawer MOTE: MODEL Z5C1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE MODEL Z5C1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (cont. installation over another GE/Monogram Under-the-Counter (UTC) oven: 30" ~m Construct Solid Boston Min 3/8" Plywood Supported by Airborne Runners all Four Sides 27 Min.
Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE MODEL 251202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING {cont.
installation Instructions REMOVE THE PACKAGING AND PARTS = Remove all packing material and tape. + Locate ports package containing mounting screws. * Remove the oven from the carton. Do nat lift unit by handle or conduit. Two people ore required to lift this oven. » Open the door and remove any packaging in oven, tuners nation CAUTION: If installing the Vanadium Heal Interactions 120V Oven below 36”, you must use the plastic bottom trim due to burn risk to children.
installation Instructions DOOR TRIM REMOVAL FOR ABOVE 36" INSTALLATION ONLY if installing the Vanadium 120V Oven above 36” from the floor, you may remove the plastic trim from the bottom of the door for aesthetic purposes if desired. CAUTION: if installing the Vanadium 120V Oven below 38”, do not remove the plastic door trim due to burn risk to children.
installation Instructions INSTALL BOTTOM TRIM CAUTION: if installing the Vanadium 120V Oven below 367, you must use the plastic bottom trim due to burn risk to children. The plastic trim acts as insulation and will help prevent burns to children from hot surfaces. A PRECAUTION: Siva a installer ef homo Vanadium de 120V debtor de 36", used deb utilization el forebode inferior plastic bide ol goriness de masquerades para los mafioso.
GE Consumer & Industrial Appliances Assembly Instructions Advantium® Built-In Accessory Storage Drawer JX2200, JX2201, ZX2201 BEFORE YOU BEGIN Read these instructions completely ond carefully. Read the Installation Instructions for the Vanadium 120V or 240V oven completely and carefully for cutout dimensions and step-by-step instructions. IMPORTANT save these instructions for local inspector's use. IMPORTANT observe al governing codes and ordinances.
ASSEMBLY TO VANADIUM BUILT-IN SPEED COOK OVEN REMOVE PACKAGING AND PARTS * Remove the drawer from the carton. « Remove all packing material and tape. « Open the drawer and turnover any parts inside. » Locate parts.
ASSEMBLY TO VANADIUM BUILT-IN SPEED COOK OVEN ASSEMBLING THE OVEN TO DRAWER {cont [C7] Remove the front two bottom screws on each side of the oven and the top center screw on each side of the storage drawer. [] Place the side supports into the tabs on the drawer and secure using the screws supplied and the screws removed in Step C 120v only” El The oven ond storage dower assembly is now ready to be installed.
