Installation guide

Installation Instructions

ADAPTING BLOWER

FOR RECIRCULATION

NOTE:The exhaust adaptor with damper is not

needed for recirculating models. You may want

to save them for possible future use.

[_3 Remove and save screws that hold blower plate

to the oven.

i_ _ BlowerPlateScrews

_-_-- BackofOven

[_3 Slide the blower plate from under its retaining

flange and lift it off. Remove and save screw that

holds the blower motor to oven.

Retaining __

Flange _ _ "___..... _,_

_ -___,_7 _ BlowerPlate

Screw

[_3 Carefully pull out the blower unit. The wires

will extend far enough to allow you to adjust

the blower unit.

[_ Roll the blower unit 90° so that fun blade openings

are facing toward the front of the oven.

Roll

/ Jl IJl

NOTE: Make sure wires remain routed in the grooves

of the motor frame.