Installation guide

Installation Instructions
B5) MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon grommet
dround the power cord hole to prevent cutting of the
cord.
NOTE: We recommend using filler blocks if the cabinet
front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from over
tightening screws.
NOTE: When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1-3. Do not pinch
core oF int oven by Lift oven, tilt it
pulling cor oe forward, and hook
slots at back bottom
edge onto two lower
“
Rotate front of oven up
against cabinet bottom.
3 |Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely tightened
later.) Be sure to keep power cord tight. Be careful
not to pinch the cord, especially when mounting
flush to bottom of cabinet.
tabs of mounting plate.
18
Cabinet Front
J Cabinet Bottom Shelf
4 Filler Block
Tr i |
y Equivalent
to Depth
Vy of Cabinet
il Recess < C
N Self-Aligning Screw
Oven Top
Attach the oven to the top cabinet.
Insert 2 self-aligning screws
(Ya"-28 x 3¥«”| through outer
top cabinet holes. Turn two full
turns on each screw.
(6 | Tighten center
screw completely.
NOTE: Use self-aligning screw, 4-28 x 2%8”, on
PVM1790 and self-aligning screws, 4-28 x 3¥%4”,
on PSA1200 and PSA2200.
|7 | Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
Install grease filters. See the Owner’s Manual
packed with the oven.