Installation Guide

STEP 11B INSTALL STAINLESS STEEL UNIFIED GRILLE FRAME

Two people are required to install the Grille Panel.

• Align the extruded holes on the unified stainless steel

grille panel with the leftmost hinge. Drive 3 screws

through the hinge and into the panel. Drive 3 screws

through the rightmost hinge and into the panel. Repeat

for the center hinges.

• Grasp grille panel at the center and pull down to close.

The panel should align evenly with the side of the door.

NOTE: To adjust the grille panel backward or forward,

loosen the 2 attachment screws on all 4 hinges. Slide the

grille panel outward or to the back. Tighten the screws.

Attachment

Screws

Grille Panel

INSTALLATION INSTRUCTIONS

STEP 12 INSTALL CENTER TRIM STRIP

• Open doors fully.

• The case trims should be evenly aligned top

to bottom with a slight gap between them.

• Starting at the top, press center u-shaped

trim strip (D) over the inside case trims of

both refrigerators.

• Continue pressing trim until you reach the

bottom of the case trims. The trim should

align with the top and bottom of case trims.

Case Trim

U-Shape

Trim

31-1000414 Rev. 1