Installation Guide

INSTALLATION INSTRUCTIONS
STEP 11A INSTALL CUSTOM PANEL UNIFIED GRILLE FRAME
• Remove 4 screws holding center hinge stiffeners to the
small brackets on the unified frame. Retain screws; use
tape to hold small brackets in place.
• Place the unified grille panel frame over the hinges on
the left and right ends, matching screw hole locations.
Install supplied black screws (L) through hinge and into
stiffener on both ends.
• Loosen screws on each side of the trim behind the
frame. Remove bottom trim.
INSERT CUSTOM PANELS
• Slide framed or overlay panel over the metal backer
panel and into the trim. If necessary, tap with a wood
block until panel slips under the top trim piece.
• Reassemble bottom trim. Tighten screws.
SECURE PANEL TO CENTER HINGES
• Reinstall middle stiffeners and slide them to meet the
center hinges.
• Install supplied black screws (L) through center hinges
and into stiffeners.
• Tighten original screws through the stiffeners and into
the small brackets at the bottom trim.
• Grasp grille panel at the center and pull down to close.
NOTE: Check alignment of grille panel to top of doors.
To adjust, loosen bracket to hinge screws on all 4 hinges.
Adjust and tighten screws.
Grille Panel
Remove
Screws
Stiffeners
Tape
Brackets
in Place
Loosen
Side
Trim
Screw
Loosen
Side
Trim
Screw
Slide Panel Into Frame
Backer Panel
Metal Panel
Overlay Panel
Spacer
3/4" Overlay Panel
Custom Panel
Metal Panel
Framed Panel
Grille Panel
Install
Screws
Through
Stiffeners
and Into
Brackets
Stiffeners
Brackets
Install Screws
Through Hinge
and Into Stiffener
14
31-1000414 Rev. 1