Installation Guide

INSTALLATION INSTRUCTIONS
Anti-Tip Wall Bracket
Bolt
Wall Toggle
Drywall or
Steel Stud
STEP 9 INSTALL ANTI-TIP BRACKET (Cont.)
Install Wall Toggles:
The wall toggles and bolts can be ordered as Service Kit
#WR49X10193. Wall toggles are installed in the drywall
and metal studs for stability. Install the wall toggles as
follows:
• Drill 1/2”
(1.27 cm)
holes at the wall markings made in
the holes at the ends of the wall bracket.
Hold the metal channel flat against the plastic straps
and slide the channel through the hole.
Gently pull back at the ends of the plastic straps to
make the channel rest flush behind the wall.
Hold the ends of the straps in one hand and slide the
plastic cap along the straps until the flange of the cap
is flush with the wall.
Place your thumb between the plastic straps and bend
up and down to snap the straps off at the wall.
Install Screws and Bolts:
Have someone hold the wall bracket centered in place
with each of the holes aligned with the correct opening
in the bracket and level with the horizontal line.
Insert the lag screws through the bracket and into the
stud. Tighten with a wrench.
Insert the bolts into the toggle by hand until snug.
Tighten with a wrench.
Plastic Straps
Metal Channel
Cap
Wood Stud
Lag Screw
Anti-Tip Wall Bracket
12
31-1000414 Rev. 1