Installation Guide

Diffuser Replacement Steps
IND126-081314
GE Lighting • 1-888-MY-GE-LED (1-888-69-43-533) • www.gelighting.com
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand and logo are trademarks of the General Electric Company.
© 2014 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Place front bezel with diffuser on table. Unfasten
the two rail screws on the end rail with latches,
then remove this end rail.
3
Reattach end rail with screws.
5
1 2
Rotate latches to unlock the front bezel. Swing down panel and lift off front bezel with
diffuser.
Remove the old diffuser by sliding it toward the
side without end rail. Insert new diffuser, keeping
the round corner of diffuser on bottom right.
Locate round corner here
4
Hang panel on its hinges and swing up into place.
Rotate latches on front bezel to fasten it.
Note: Front side of diffuser should face outward.
6
NOTE: The following steps depict the 22 Series luminaire. However, the procedure is the same for the 14 and 24 Series xtures.