Installation Guide

3
Move brackets to desired
locations. Ensure brackets are
not blocking wire access holes.
4 5 6
Use provided M4 tapping screws
only. Turn each screw into
bracket at an even amount so
the bracket is push up by the
screws evenly, until it is secured.
Repeat Step 4 for the other
bracket.
Follow local building codes and
acceptable mounting options.
When using shoulder-bolt or
threaded rod, 1/4”-20 or M6 is
recommended for mounting
into the ceiling structure. Use
nut above and below bracket to
prevent xture movement.
Brackets Installation
1
Carefully unpack unit from its
packaging. Properly inspect for
defects before installing. Wear
work gloves to prevent dirt and
oil from being transferred to the
luminaire.
2
Slide brackets into the top
grooves of the xture as shown.
Use one bracket on each end of
the xture.
IND124-072514
GE Lighting • 1-888-MY-GE-LED (1-888-69-43-533) • www.gelighting.com
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. The GE brand, logo, and Lumination are trademarks of the General Electric Company.
© 2014 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.