Installation Guide

1
For the luminaires that will be in the middle of the
run, insert two pins into one end only. Slide pins into
the bottom screw grooves, leaving approximately
20-22mm exposed.
2
Pre-install the two M3x12 mm screws with the
wingnuts into bracket. The screws should be in the
same hole type.
3 4
5
Insert four mounting brackets (two at each end)
into grooves on both sides of luminaire. Position
brackets approximately 2-3mm from ends. Do
not tighten wingnuts yet.
Fasten one end cover on the rst and last
luminaires only with four M3 screws. Always use a
star washer under one of the top screws to ensure
ground continuity.
Note: The luminaires between the opening and
closing units do not require end covers.
Place luminaires into ceiling grid.
Do not
tighten yet
Groove
Must use star
washer on top hole
End cover
First luminaire
Middle luminaire(s)
(up to 8 units)
Last luminaire
End coverNo end covers
20-22mm
Pins
Ceiling grid
Pins
Joiner pin