Installation Guide

ManualsBrandsGE ManualsIndoor FixturesGE BL Series

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class

[A] RFLD complies with the Canadian standard ICES-003. Ce DEFR de la classe [ A ] est conforme ‡ la NMB-003 du Canada.

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to

cause harmful interference in which case the user will be required to correct the interference at his own expense.

IND034-051713

1326613

GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com

1-888-69-43-533

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Lumination is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.

Troubleshooting

Symptom Solution

Luminaire does not light • Check input voltage and check power supply input/output connections.

• Check circuit breaker.

Luminaire is dim • Maximum recommended supply wire length is exceeded. Refer to EP147 installation guide

for Maximum Driver Remote Mounting Distance.

Luminaire is blinking • Ensure power supply temperature does not exceed its maximum rating.

• Refer to the tc point located on power supply.

Luminaire does not dim • Check dimming wire connection.