Installation Guide

5
For added safety, use additional celing grid screws
to permanently x bracket to grid.
2
4
1
3
Fasten mounting brackets over screws by using
two M3 wingnuts for each bracket but do not
tighten them at this point. Note that bracket aps
have to be aligned with the groove.
Fasten the wingnuts of the mounting brackets by
hand, being careful not to strip the threads.
Slide four M3x12 bracket mounting screws into
housing groove on each side (eight screws per
housing are required). If the screw head cannot
pass through end cover groove, remove end
covers and slide the screw head directly into the
housing groove, then re-install end covers.
Mount xture into grid system.
One safety screw is
mandatory, additional
screws are optional
Do not
tighten yet
Always use two
screws per bracket
WARNING
Risk of Injury. Improper mounting bracket
installation may cause injury or property damage.