Installation Guide

2
3A 3B
Remove end cover closest to the cable glands.
Retain star washer for reinstalling end cover.
Two diffusers: Slide both diffusers into base
of luminaire, making sure the diffuser with the
green protective lm is placed on the bottom.
One diffuser: Slide diffuser into base of luminaire.
1
Carefully unpack unit from its packaging. Properly
inspect for defects before installing. Wear
work gloves to prevent dirt and oil from being
transferred to the luminaire.
Bottom: Diffuser with
green lm faces up.
Remove before sliding in.
Top: Diffuser with no lm
Retain star washer
Two diffusersOne diffuser
Diffuser Installation
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be supplied with 100-277 VAC, 60 Hz and connected to an individual properly
grounded branch circuit, protected by a 15 or 20 ampere circuit breaker. Use min. 600V 75°C supply conductor.
Grounding Instructions
• The grounding and bonding of the overall system shall be done in accordance with National Electric Code
(NEC) Article 600 and local codes.