Installation Guide

Batten Replacement Instructions
Loosen mounting bracket screws on the Batten xtures preceding the xture to be replaced (either xtures 1,2 or
4,5). This will help the xtures to slide in Step 2
Unclip plug on the side with the loosened mounting
bracket screws and slide Battens at least 2 inches
to disengage.
TIP: Pinch the ends of the plug while pulling the
receptacle end away.
Loosen the screws on all mounting brackets on
the Batten to be replaced, so that the screws are
still holding the xture, but will allow it to slide.
Unclip the plug on the other side. Completely unscrew the previously loosened
screws on all mounting brackets of Batten to be
replaced and remove the Batten.
To insert new Batten, complete steps 1-5 in reverse order.
NOTE: The following scenario is based on replacing the third xture in a series of ve.
1
2 3
4 5
6
1 2 3 4 5
Loosen mounting bracket screws for xtures 1, 2 or 4,5
Pinch
Pinch
Batten to
be replaced
Slide loosened
Battens 2 inches
Unplug Batten
to be replaced
Mounting surface
Loosen brackets
Batten to
be replaced