Room Air Conditioners Manual

COOL MODE
Remote Control
1. Press COOL pad.
2. Press LOW or HIGH pads to set desired fan speed.
3. Press the ,1&5($6('(&5($6(²pads to set the desired
temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the MODE pad until the COOL indicator light is lit.
2. Press the FAN pad until HIGH or LOW indicator light is lit for desired
fan speed.
3. Press the,1&5($6('(&5($6(²pads to set the desired
temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature. The
compressor will cycle on and off to keep the room at the set level of
comfort. Set the thermostat at a lower number and the indoor air will
become cooler.
Set the thermostat at a higher number and the indoor air will become
warmer.
NOTE: If the air conditioner is off and is then turned on while set to
COOL, it will take approximately 3 minutes for the compressor to start
and cooling to begin.
Cooling Descriptions
)RU1RUPDO&RROLQJ³Select the COOL mode and HIGH fan with a
middle set temperature.
)RU0D[LPXP&RROLQJ³Select the COOL mode and HIGH fan with a
lower set temperature.
)RU4XLHWHUDQG1LJKWWLPH&RROLQJ³Select the COOL mode and LOW
fan with a middle set temperature.
NOTE: There will be a 3-minute delay between setting changes such
as COOL to OFF and back to COOL.
FAN
Use the FAN to provide air circulation and filtering without cooling or
heating. Since fan only settings do not provide cooling or heating, a
temperature setting will not be displayed.
Remote Control
Press FAN pad. Press LOW or HIGH pads to set desired fan speed.
Control Panel
Press the MODE pad until the FAN indicator light is lit and the LOW or
HIGH indicator light is lit for the desired fan speed.
HEAT MODE
Remote Control
1. Press HEAT pad.
2. Press LOW or HIGH pads to set desired fan speed.
3. Press the ,1&5($6('(&5($6(²pads to set the desired
temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the MODE pad until the HEAT indicator light is lit.
2. Press the FAN pad until HIGH or LOW indicator light is lit for desired
fan speed.
3. Press the ,1&5($6('(&5($6(²pads to set the desired
temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature. The heater will
cycle on and off to keep the room at the set level of comfort. Set the
thermostat at a higher number and the indoor air will become warmer.
Set the thermostat at a lower number and the indoor air will become
cooler.
NOTE: If the air conditioner is off and is then turned on while set to
HEAT, it will take approximately 1 minute for the heater to start and
heating to begin.
Heating Descriptions
)RU1RUPDO+HDWLQJ³Select the Heat mode and HIGH fan with a
middle set temperature.
)RU0D[LPXP+HDWLQJ³Select the HEAT mode and HIGH fan with a
higher set temperature.
)RU4XLHWHUDQG1LJKWWLPH+HDWLQJ³Select the HEAT mode and LOW
fan with a middle set temperature.
7