Manual

Window Installation Instructions
l'_ WINDOW REgUIREMENTS
, These instructions are for a standard
double-hung window. You will need to modify
them for other types of windows.
, CAUTION: If the sill support bolts
do not contact the window sill or if you have a
window without a sill, you must order accessory
kit RAK87 to properly install this air conditioner.
Call 800.626.2002 or visit GEAppliances.com.
, All supporting parts must be secured to firm
wood, masonry or metal.
, The electrical outlet must be within reach of
the power cord.
m
P
1
16.4" min T
27" to 36"
(With accordion ponels)
[_] STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will
keep it from draining properly. To adjust for this,
attach a piece of wood to the stool.
WOOD PIECES-
WIDTH: 2"
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: The top of the wood should be 1/2"
higher than the top of the storm window frame
or the vinyl frame.
Attach securely with nails or screws provided
by the installer.
1/2" higher
than storm
window
frame
1/2" higher
than vinyl frame
_ (on some windows)
Stool
Storm window
frame
Vinyl frame
Wood
9
[] REMOVE THE AIR CONDITIONER FROM
THE CASE
[] Remove and save the 2 screws from the lower
sides of the front grille.
FRONT
r_ Grasp the lower corners of the grille while
pressing in on the case sides with your finger
tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you
more than 3" or you may damage the tabs of
the grille.
t t
FRONT
[] When the front grille is removed the control
panel will still be attached by a harness.