Manual

Before you call for service...
Troubleshooting Tips
Save time and money! Review the chart below first
and you may not need to carl for service.
GEAppliances.com
Passible Causes What To Do
The air conditioner • Hake surethe air conditioner plug is pushed completely
does not start is unplugged into the outlet.
The fuse is blown/circuit • Checkthe house fuse/circuit breaker box and replace
breaker is tripped the fuse or reset the breaker.
Power failure • Theunit will automatically re-start in the settings last
used after the power is restored.
• There is a protective time delay (approximately
3 minutes) to prevent tripping of the compressor
overload. For this reason, the unit may not start
normal cooling or heating for 3 minutes after it
is turned back on.
The current interrupter
device iS tripped
• Pressthe RESETbutton located on the power cord plug.
• If the RESETbutton will not stay engaged, discontinue
use of the air conditioner and contact a qualified service
technician.
Air conditioner Ice blocks the air flow • Setthe mode control at Fen Only or Hi Cool with the
freezing up and stops the air conditioner temp control at a warmer setting.
from cooling the room
Air conditioner does not Airflow is restricted • Hake surethere are no curtains, blindsor furniture
cool as it should blocking the front of the air conditioner.
The temp control may • Turnthe temperature knob clockwise as far as possible.
not be set correctly
The air filter is dirty • Cleanthe filter at leastevery 30 days. Seethe Operating
Instructionssection.
The room may have been hot • When the air conditioner isfirst turned on you need
to allow time for the room to cool down.
Cold air is escaping • Checkfor open furnace floor registers and
cold air returns.
• Setthe air conditioner's vent to the closed position.
Cooling coils have iced up • See"Air conditioner freezing up" above.
Air conditioner does not Airflow is restricted • Hake surethere are no curtains, blindsor furniture
warm as it should blocking the front of the air conditioner.
The temp control may ,Turn the knob counterclockwise as far as possible.
not be set low enough The lowest setting provides maximum warming.
The air filter is dirty • Clean the filter at leastevery 30 days. Seethe Operating
Instructionssection.
The room may have been cold • When the air conditioner isfirst turned on, you need to
allow time for the room to warm up.
Warm air is escaping • Checkfor open furnace floor registers and
cold air returns.
13