Installation Guide

ALB006-012114

Troubleshooting

Symptom Solution

Luminaire will not turn on. • Check that the color of the supply side wires match the color of the wires they are connected to.

• Check that all wire connectors are properly connected.

• Verify that your input voltage is within specs.

• If you are using any additional controls i.e. wireless controls/motion sensors, please also verify that

those are working properly and that the unit is setup to interface with the controllers.

Mounting insert slides

from side to side.

• Check that the mounting insert is properly tightened using the adjustment screws provided.

Endplate of Pendant Mount Kit

does not snap in place.

• Check that the top plate is properly slotted in main bracket.

• Check that endplate tabs are properly aligned in pendant mount bracket assembly.

• Check that endplate is pushed rmly into place.

Attach pendant mount bracket assembly to four

mounting inserts on the xture with (8) 10-32 x 3/8”

Philips pan head screws.

Slide top plate into main bracket. Align top tabs of end

plate with slots in main bracket and push endplate into

place.

Attach top plate to 3/4” conduit and pass AC input wires

through conduit, top plate, and locking nut (if used).

Connect the AC input wires to the xture wires coming

from the strain relief in the main bracket assembly

bottom plate.

Fasten endplate to bracket with a 8-32 x 1/4” Philips pan

head screw. Fasten endplate to mounting hub with a

6-32 x 1/2” hex head screw.

Pendant Mount Kit

OPTION B

AC line

Align tabs

Fasten screws

NOTE: Pendant Mount Kit cannot be used with the 6-module xture.

GE Lighting • 1-888-MY-GE-LED (1-888-69-43-533) • www.gelighting.com

The GE brand, logo, and Albeo are trademarks of the General Electric Company.

Conforms to the following standards:

UL 1598 Suitable for Damp Locations