Installation Guide

Electrical Connections (347/480V)
Optional Mounting Methods
1 2
Attach two rod mount brackets to xture using four
10-32 x 3/8” pan head screws per bracket.
Secure 1/2” threaded rods into structural members in
ceiling. Place a nut on each threaded rod where xture
should hang. Slide xture onto threaded rods and tighten
second nut onto rods to secure xture.
Rod Mount Kit
OPTION A
Attach to
structural member
Fasten with nuts
1
4
2
Loosen screws to remove endcap.
Using UL listed wire connectors, connect AC source green
to xture green (ground), and AC black and red to xture
black and red. Reattach endcap.
Option: power input from top – A) Install 1/2” conduit, or
B) install AC power cord with strain relief.
A) Conduit B) Power cord
3
Option: power input from side – Remove knockout in endcap
and A) Install 1/2” conduit, or B) install AC power cord with
strain relief. Plug unused hole on top with appropriate tting.
A) Conduit B) Power cord
0-10V Dimmer
Optional Installation: 0-10V Volt Dimming
Black
To AC Main
White
Green/Yellow
Violet
Grey
Blue/White
Black/White
Yellow
Line
Neutral
Ground
0-10V(+)
0-10V(-)
LED Driver
To 0-10V
Dimmer
Run wires from controller through a different
knockout than the AC input wire. At output side of
LED driver, make appropriate connections using
twist-on wire connectors. Follow lighting controller
installation instructions.
Note: Daisy chaining the 0-10V wires from xture
to xture for the 347-480V versions of ABHG is not
allowed.