Owner manual

Preparing the Motion Sensor for Installation

The Motion Sensor consists of 2 parts – The Sensor

(Transmitter) and the wall mount. Before installing,

remove the screw from the battery door on the back

of the Sensor. You’ll need to attach the battery leads

to a “9V” battery (not included); Take care to note the

polarity markings. Replace the battery cover and

secure screw. An Alkaline “9V” battery in the Motion

Sensor can last up to 9 months,

Before mounting the Motion sensor, you’ll need to

assign the Sensor to a zone on the Control Center.

Follow these steps to assign a Sensor to a Zone.

Step 1 – Press and hold the Learn button on the

Control Center for three seconds. After the

Control Center sounds a long beep, release the

Learn button.

Step 2 – Press the Zone button (1, 2, 3 or 4) for the

Zone you want to assign to the Motion Sensor.

The LED indicator for that Zone will begin to ﬂash.

Step 3 –

Release the Zone button.

Note: Zone 4 is for dedicated alerts only. Sensors in this Zone

will not trigger an alarm or chime.

Step 4 – Activate the Motion Sensor

0 1 2 3 4 5 6 7 8 9 10 11 12 13

DETECTING AREA: (Unit = meter)

55∞

22∞

12∞

SENSOR

27∞

55∞

1.2M

11∞