Full Product Manual

Surge Protector Instructions
1. Set the power switch to the “OFF” position. Plug the surge protector into
a standard grounding wall receptacle by fully inserting the plug and ensure
that there are no exposed conductors.
2. Make sure electronic equipment is turned off before plugging into the surge
protector outlets. Do not use extension cords to connect equipment to the
surge protector.
3. Plug the phone line into the “Phone” jack marked “IN.” Insert one end of
another phone cord to the “OUT” jack and other end into the device being
protected.
4. Screw the coaxial cable line-in onto the “Cable” jack marked “IN”. Attach
one end of another coaxial cable to the “OUT” jack and the other end to the
device being protected.
5. Set the power switch to the “ON” position. The surge protector will now be
providing power and surge protection.
6. Connected equipment can now be turned on.
NOTE: Check the blue “Protected” and green “Grounded” indicator lights periodically.
A glowing blue indicator light shows that surge protection is being provided. If the blue “Protected” indicator
light stops glowing, the surge protective components have expired* and the power has been permanently
shut down to the outlets, ensuring surge protection for your electronic equipment.
A glowing green indicator light shows that your surge protector is plugged into a grounded receptacle and
that your surge protector’s ground protection components are providing protection from ground surges.
If the “Grounded” indicator light stops glowing, it is possible that the surge protector’s ground protection
components have expired or that the wall receptacle is no longer grounded.
Surge Protector — Limited Lifetime Warranty
Jasco Products Company warrants this surge protector to be free of defects
in workmanship and/or materials for the life* of the surge protector. If such
a defect should arise during the life of the surge protector, Jasco Products
Company will, at its option, either repair or replace the surge protector without
charge. This warranty does not cover damage caused by lightning, accident,
misuse, or alterations to the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan. Even under normal circumstances and
in the absence of defects, the product’s life will expire when the surge protector’s component capacity
has been exceeded, thereby ceasing to provide protection from surges. In this event, the Limited-Lifetime
Warranty is no longer valid and the surge protector should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco
Products Company surge protector, freight prepaid, to Jasco Products
Company. Surge protectors returned to Jasco Products Company must
have an RA# included in the mailing address to be accepted.
3. The original purchaser will be asked to send the surge protector, a copy of
the sales receipt for the product, your name, address, phone number and a
description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 30826
Maximum Warranty Amount: $300,000(USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection when lightning strikes
nearby power line, the house, service entrance or antenna. The Warranty is void if a power disturbance
damages your equipment through the network line.
Jasco Products Company will pay up to the maximum warranty amount
offered for the surge protector purchased to repair or replace up to an
amount equal to the fair market value or the original purchase price,
whichever is less, of your electronics equipment, if damaged by a transient
surge (except those caused by direct lightning), within the life* of the surge
protector, while properly and directly connected to this surge protector. Jasco
Products Company DISCLAIMS AND ASSUMES NO LIABILITY FOR ANY OTHER
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED
TO LOSS OR DAMAGE TO SOFTWARE OR DATA OR DAMAGES OR COSTS
ASSOCIATED WITH BUSINESS INTERRUPTION OR OTHER DAMAGES DUE TO
LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE OR DATA. Some states do not
allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you. This warranty gives
you specific legal rights, and you may also have other rights that may vary
from state to state.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer’s warranty,
extended warranties, or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged into
properly wired and grounded outlets, no extension cords, adapters,
other ground wires, or electrical connectors may be used, with the sole
exception of other standard Jasco Products Company 120 volt products
approved for that use. The installation must comply with all applicable
electrical and safety codes set forth pursuant to the National Electrical
Code (NEC.)
3. Any claim under the warranty policy must be made within 15 days of the
date of the alleged damage to the connected equipment.
For connected equipment coverage, the following conditions must
be satisfied:
A. All equipment eligible for warranty coverage must be plugged directly
into the Jasco Products Company surge protector. Equipment connected
to the protected equipment, but not plugged directly into the surge
protector will not be covered.
B. The equipment must have been damaged by a covered power
disturbance that passed through the Jasco Products Company
surge protector.
C. The Jasco Products Company surge protector must be found defective.
D. The Jasco Products Company surge protector’s protection capacity must
not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at 1-800-
654-8483 to get a Return Authorization Number (RA#), shipping
instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return the Jasco
Products Company surge protector, freight prepaid, to Jasco Products
Company. Surge protectors returned to Jasco Products Company, Inc.
must have an RA# included in the mailing address to be accepted.
3. Jasco Products Company will determine whether the damage to your
equipment is covered by this warranty policy. If you are covered, a claims
adjuster will contact you and Jasco Products Company will do one of the
following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged equipment.
d) Reimburse customer the initial purchase price of the damaged equipment
(customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether the
damage to the connected equipment is due to Jasco Products Company
surge protector failure by requesting that damaged equipment be sent to
Jasco Products Company for inspection.
30826 v2
02/22/16 RT
MADE IN CHINA / HECHO EN CHINA
GE is a trademark of General Electric Company
and is under license by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime warranty.
Visit www.jascoproducts.com for warranty details and product registration.
Questions? Contact us at 1-800-654-8483 between 7:30AM—5:00PM CST.
RISK OF ELECTRIC SHOCK
• DO NOT USE IN WET LOCATIONS
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
• FULLY INSERT PLUG
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL RATINGS
NOT FOR USE WITH
• AQUARIUMS OR OTHER
WATER-RELATED PRODUCTS
• GENERATORS AND POWER INVERTERS
• MEDICAL LIFE-SUPPORT PRODUCTS
WARNING