SDS

IDH number: 2764352
Product name: GE Supreme Silicone Kitchen & Bath Projects
Page 2 of 5
4. FIRST AID MEASURES
Inhalation:
If not breathing, give artificial respiration. If breathing is difficult, oxygen
should be administered by qualified personnel. Move to fresh air. If symptoms
persist, seek medical advice.
Skin contact:
Wipe off with paper towel or cloth. Rinse with running water and soap.
Remove contaminated clothing and shoes. Wash contaminated clothing
before reuse. Thoroughly clean shoes before reuse. Seek medical attention
immediately.
Eye contact:
Rinse immediately with plenty of water, also under the eyelids, for at least 15
minutes. Seek medical attention immediately.
Ingestion:
DO NOT induce vomiting unless directed to do so by medical personnel.
Never give anything by mouth to an unconscious person. Seek medical
attention immediately.
Symptoms:
See Section 11.
5. FIRE FIGHTING MEASURES
Extinguishing media:
Foam, dry chemical or carbon dioxide.
Special firefighting procedures:
Wear self-contained breathing apparatus and full protective clothing, such as
turn-out gear.
Unusual fire or explosion hazards:
Closed containers may rupture (due to build up of pressure) when exposed to
extreme heat. In case of fire, keep containers cool with water spray.
Hazardous combustion products:
Oxides of carbon. Oxides of silicon. Formaldehyde. Toxic and irritating vapors.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and
unprotected personnel.
Environmental precautions:
Do not allow product to enter sewer or waterways.
Clean-up methods:
Ensure adequate ventilation. Wear appropriate personal protective equipment.
Refer to Section 8 "Exposure Controls / Personal Protection" prior to clean up.
Soak up with inert absorbent material (e.g. sand, silica gel, acid binder,
universal binder, sawdust). Scrape up spilled material and place in a closed
container for disposal.
7. HANDLING AND STORAGE
Handling:
Use only with adequate ventilation. Vapours should be extracted to avoid
inhalation. Avoid contact with eyes, skin and clothing. Do not wear contact
lenses. Do not handle contact lenses until all sealant has been removed from
hands. Residual sealant may transfer to lenses and cause eye irritation. Wash
thoroughly after handling. See Section 8 of the SDS for Personal Protective
Equipment. Keep container closed.
Storage:
Keep in a cool, well ventilated area away from heat, sparks and open flame.
Keep container tightly closed until ready for use.
For information on product shelf life, please review labels on container or check the Technical Data Sheet.