Owner's Manual

Code Search

If your product does not respond after you have tried all

the codes for your brand, or if your brand is not listed,

try searching for your code by following these steps.

1. Manually turn on the device (TV, DVD, etc.) to be

controlled.

2. Press and hold the SETUP button until the red

indicator stays on, then release the SETUP button.

3. Press and quickly release the desired mode button

(TV, DVD, etc.). The red indicator blinks off once.

4. Press the CHANNEL UP button repeatedly (up to

300 times) until the device to be controlled changes

channel. The red indicator blinks off with each

button press. If you accidentally overshoot the code

required, press the CHANNEL DOWN button

to backtrack through the library until the device

changes channel. Pressing CHANNEL UP changes

direction to forward again.

5. Press and release ENTER to install the code.

Most users will store DVD codes under the DVD but-

ton, Cable codes under CABLE, etc. If (for example)

you want to store a DVD code under CABLE, rst

follow the procedure for Direct Code Entry (previous

page) and press CABLE in step 2 of Direct Code Entry,

then enter ANY DVD code in step 3 of Direct Code

Entry. Then follow the steps for Code Search on the pre-

vious page. Note: If the device does not have a CHAN-

NEL UP button, use PLAY (DVD only) or ON-OFF

instead. Code Search starts from the currently stored 4

digit number under that mode.