Owner's Manual

11
and Off Buttons, cont.
To turn the TV off, press and release the ON-OFF
button to transmit the Power Off button command.
This method can be applied similarly to any device
and is available for all Modes. Note this feature is not
supported by all codes.
VCR/DVD/DVR Punch-Through Feature
This remote allows the 6 VCR transport buttons (i.e.
PLAY, PAUSE, STOP, FF, REWIND, and REC) to
Punch-Through control from any Mode programmed
with TV, SAT or Cable codes to the last VCR, DVD
or DVR programmed Mode you used. Normally other
types of remotes only punch-through (from another
Mode) on the 6 VCR buttons to the device programmed
under the VCR Mode button. This is not much use if
you are using a DVD programmed under a Mode other
than VCR. For example, if you have 3 DVD, VCR or
DVR devices programmed into this remote, the last one
you accessed on the remote will be the one that has con-
trol of the 6 VCR transport buttons when in any other
Mode. This feature will not operate if the programmed
TV, SAT or Cable code has its own VCR transport but-
ton control e.g. a TV Combo, SAT/PVR, etc.
Volume/Mute Control and Punch-Through Feature
This remote lets you select which device Mode controls
your Volume/Mute buttons. The remote is initially set
(factory default) for all device Modes programmed
with “Visual” codes (e.g. TV, VCR, DVD, DVR, SAT
& CABLE) and “Audio” codes (e.g. CD & AUDIO)
to use their own Volume/Mute control if present. If
the programmed “Visual” code has no Volume/Mute
operation of its own then those buttons will punch-
through control to the TV Mode device without needing
to change to TV Mode. Please refer to the next page for
more information.
Setup, cont.