Instructions / Assembly

INSTALLING THE LIGHT KIT

Remove 1 of the 3 mounting plate screws (Q) from the

mounting plate of the motor assembly and loosen the other

2. Guide the single pin connector through the center hole

on the metal housing (F). Raise the metal housing (F) up to

the mounting plate, position keyhole slots around the

mounting plate screws (Q) and twist clockwise. Insert the

mounting plate screw (Q) that you had previously

removed. Tighten all screws.

Fan Installation

Remove 3 LED light kit mounting screws (R) from the

metal housing (F), and save for later use.

Securely attach shade (H) by twisting clockwise onto the

metal housing (F).

Attach the single pin connectors from the LED light kit (G) and

motor assembly, white to white and black to black. Align the

3 screw holes on the LED light kit (G) to the holes on the metal

housing (F). Insert the 3 LED light kit mounting screws (R) that

you had previously removed. Tighten all screws.

ATTACHING THE FAN BLADES

Attach blade plate (K) to blade (I) and blade holder (J)

as above figure shows. Secure with three blade screws (EE).

Attach the blade assembly to the motor assembly. Line

up the holes in the blade holder (J) with the holes in the

bottom of the motor body (marked A-A, B-B, C-C). Secure

with two blade holder screws (FF).

Note: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box.

Turning power off using the fan switch is not sufficient to prevent electric shock.