Instructions / Assembly

FINISHING THE FAN INSTALLATION
Fan Installation
9.
11.
Align the slotted hole on the canopy trim ring (C) with
the mounting bracket push lever, Take both hands
and push the canopy trim ring (C) up to the top of the
canopy (B). The canopy trim ring (C) will snap and lock
into place on the canopy (B) .
B
C
10.
Tighten all the 4 canopy mounting screws (M).
M
12
M
7.
Rotate the canopy to the right (clockwise), continue
turning the canopy until the screws (M) lock into
place on the receptacle j slots.
Note: You may need to loosen the canopy screws
slightly, if you find it's difficult to lock the screws
into the receptacle j slots.
8.
Groove
Tab
B
Make sure the tab on the mounting bracket socket
is properly seated in the groove in the hanger ball/
downrod assembly (B). This will help to balance the
ceiling fan.
WARNING: Failure to properly seat the tab in the
groove could cause damage to wiring.
B
Plug locking
A
Locking pin terminal
Mounting bracket
push lever
To install the fan, raise the assembled fan housing up to,
the ceiling receptacle (A). Press up on the push lever while
lifting the fan canopy (B) up to the receptacle (A) fully
inserting the fan plug locking pin into the receptacle
locking pin terminal. For correct alignment, make sure
the mounting bracket push lever on the canopy is placed
in the middle between the receptacle j slots as shown in
the picture. Keep the lever pushed up while turning the
fan to the right (clockwise) as shown in step 8.
pin
J slot