Owner's manual

9
Most users will store VCR codes under the VCR button, Cable codes
under CABLE, etc. If (for example) you want to store a VCR code
under CABLE, first follow the procedure for Direct Code Entry (previ-
ous page) and press CABLE in step 2 of Direct Code Entry, then
enter ANY VCR code in step 3 of Direct Code Entry. Then follow the
steps for Code Search on the previous page. Note: If the device
does not have a CHANNEL UP button, use PLAY (VCR only) or ON-
OFF instead. Code Search starts from the currently stored 3 digit
number under that mode.
Code Search, cont.
Code Identification Feature
The Code Identification Feature allows you to identify the three digit
library code stored under your device key. For example, if you want
to find out what three digit code is stored under your TV device key,
follow the six steps below:
1. Press and hold the SETUP button until the green indicator stays
on. Release the SETUP button.
2. Press and release the desired mode button (TV, VCR, etc.). The
green indicator blinks, then stays lit.
3. Press and release the SETUP button. The green indicator blinks
off.
4. To find the first digit for the code stored under the mode key
pressed in step 2, press each numeric key from 0-9 in turn.
When the green indicator blinks off the number you pressed is
the first digit for the code you are searching for.
5. To find the second digit, repeat step 4, this time when the
green indicator blinks off this is the second digit.
6. Repeat step 4 again to find the third digit.