Owner's manual

Direct Code Entry

1. Press and hold the SETUP button until the green indicator stays

on, then release the SETUP button.

2. Press and release the desired mode button (TV, VCR, etc.). The

green indicator blinks, then stays lit.

3. Enter the 3 digit code from the code tables (on separate sheet).

Note: after a valid code entry, the green indicator turns off. For

an invalid code, the green indicator ﬂashes.

4. With your device on, press CHANNEL UP. If the device

responds, no further programming is required. Note: If some

buttons do not operate your equipment, try one of the other

codes for your brand.

Code Search

If your product does not respond after you have tried all the codes

for your brand, or if your brand is not listed, try searching for your

code by following these steps.

1. Manually turn on the device (TV, VCR, etc.) to be controlled.

2. Press and hold the SETUP button until the green indicator stays

on, then release the SETUP button.

3. Press and quickly release the desired mode button (TV, VCR,

etc.). The green indicator blinks off once.

4. Press the CHANNEL UP button repeatedly (up to 300 times)

until the device to be controlled changes channel. The green

indicator blinks off with each button press. If you accidentally

overshoot the code required, press the CHANNEL DOWN

button to backtrack through the library until the device

changes channel. Pressing CHANNEL UP changes direction to

forward again.

5. Press and release ENTER to install the code.

Type Type stored Code

TV TV

DVD

VCR

SAT

AUX

CBL

AUDIO

Write your codes down here for easy reference later.