Owner's manual

7
Setup, cont.
Battery Saver
Your remote automatically turns off if the buttons are depressed
more than 30 seconds. This will save your batteries should your
remote get stuck in a place where the buttons remain depressed
(e.g., between the sofa cushions).
Code Saver
Codes are stored in permanent memory while you are changing
batteries so you will not lose any codes stored in the remote while
you are changing batteries.
Power-On Default
The remote powers on in TV mode.
Code Setup
The SETUP button is used to setup the remote. You can either setup
the remote using the code for your brand of product, from the code
tables (on separate sheet), or you can search through the library of
codes until you find a code that works for your product.
Please refer to “Programming with Code Search” on page 8 for
more information on using the code search feature to learn how to
search through the library of codes for your products.
NOTE: You can store any kind of code under any mode (except TV).
I.E. you can store a VCR code under the CBL button, or a DVD code
under the VCR button, etc. However, you can only store TV codes
under the TV button.