Owner's manual

16
The learning feature allows you to “learn” functions from your
original remote control. For example - you may want to use your
remote to operate the RANDOM PLAY feature from your original
CD remote control. This remote is equipped with an “easy learning”
feature that allows you to “learn” features (such as RANDOM PLAY
from your original CD remote) by following the steps below, and on
the next page:
1. Press and hold the SETUP button until the green indicator turns
on, then release the button.
2. Press and release the desired mode button (TV, VCR, etc.), the
green indicator blinks then stays on.
3. Press and release the LEARN button, the green indicator blinks
then stays on.
4. Press and release the Learning Remote button that you want
to teach, e.g. ON-OFF. (to learn a “shifted” key press SHIFT first).
5. Point your existing remote at the learning Remote approxi-
mately 1 inch apart (see tips on previous pages).
Learning Commands
This feature assists you in identifying where your original remotes
IR transmitter is located and is particularly useful if your original
remote’s IR transmitter is hidden behind a lens.
1. Point both remotes facing each other by approximately 1 inch
apart (see Tips on Learning on previous pages).
2. Press and hold the SETUP button until the green indicator turns
on, then release the button.
3. Press and release the desired Mode button (TV, VCR, etc.), the
green indicator blinks then stays on.
4. Press and release the LEARN button, the green indicator blinks
then stays on.
5. Press and hold any Original Remote button and move the
Original Remote to the left and right, and/or, up and down in
front of the Learning remote IR transmitter. The green indicator
will remain on if no IR from the Original remote is found and
the green indicator will blink on and off more rapidly when
the IR transmitters are lining up. The point where the green
indicator blinks most rapidly is where the two IR transmitters
are aligned. Note some original remotes will only transmit IR
on the initial button press then stop. In these cases, quickly
press and release the original remote button repeatedly during
this procedure.
6. You can now learn a button from your original remote by
continuing from “Step 4” in the “Learning Commands” section
on the next page, or, to exit at this point, press and release the
SETUP button
IR Transmitter Finder Feature