Owner's manual

11
VCR/DVD/DVR Punch-Through Feature
This remote allows the 6 VCR transport buttons (i.e. PLAY, PAUSE,
STOP, FF, REWIND, and REC) to Punch-Through control from any
Mode programmed with TV, SAT or Cable codes to the last VCR,
DVD or DVR programmed Mode you used. Normally other types
of remotes only punch-through (from another Mode) on the 6 VCR
buttons to the device programmed under the VCR Mode button.
This is not much use if you are using a DVD programmed under a
Mode other than VCR. For example, if you have 3 DVD, VCR or DVR
devices programmed into this remote, the last one you accessed
on the remote will be the one that has control of the 6 VCR trans-
port buttons when in any other Mode. This feature will not operate
if the programmed TV, SAT or Cable code has its own VCR transport
button control e.g. a TV Combo, SAT/PVR, etc.
Volume/Mute Control and Punch-Through Feature
This remote lets you select which device Mode controls your
Volume/Mute buttons. The remote is initially set (factory default)
for all device Modes programmed with “Visual” codes (e.g. TV, VCR,
DVD, DVR, SAT & CABLE) and “Audio” codes (e.g. CD & AUDIO) to
use their own Volume/Mute control if present. If the programmed
“Visual” code has no Volume/Mute operation of its own then those
buttons will punch-through control to the TV Mode device without
needing to change to TV Mode. Please refer to the next page for
more information.
Setup, cont.