7453 v2 Wireless Motion Sensing LED Spotlight User’s Manual
Thank you on your purchase of the GE LED Spotlight! Included items: Spotlight 2 - 25 mm screws and screw anchors 1 - 44 mm screw NOTE: The LED Spotlight will stay on as long as there is motion detected. Spotlight will turn off after 45 seconds if no motion is detected. The LED Spotlight only turns on in the dark to conserve battery life. Battery-Operation: Removing the front cover Remove the front cover by rotating counter-clockwise.
c. Position the base in the chosen location and drive the 44 mm screw through the top of the base (D) d. Replace the light fixture by pressing the neck back in to the base and replace the screw snuggly in to the side of the base. DO NOT OVER TIGHTEN. C D Hanging Keyhole Type Mounting FOR BEST PERFORMANCE, SPOTLIGHT SHOULD BE POSITIONED SO MOTION SENSOR IS ON TOP AND LIGHT IS ON BOTTOM. First, use included template to mark the area where the screws will be inserted.
If using screws only: 1/8” Use 1/8” drill bit to drill holes and insert 25 mm screws so that screw head protrudes 1/8” from surface( the height of the screw head). Hang the mounting base on the inserted screws and slide mounting base down so that the track is securely held by the screws. Reassembling The Unit: Once the base is secure, insert the neck and fixture back in to the large hole in the middle of the base.
7. Mounting Template X 2-1/8 in. 7.
17453-2 9/1/11 is a trademark of the General Electric Company and is under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114. This Jasco product comes with a 1 year limited warranty. Visit www.jascoproducts.com for details.
