Full Product Manual

USB Charging
Surge Protector
Instructions
1. Plug the surge protector into a standard grounding duplex wall
receptacle, covering both outlets, by fully inserting the plug and
ensure that there are no exposed conductors.
2. The surge protector will now be providing power and surge
protection.
3. Make sure electronic equipment is turned off before plugging
into the surge protector outlets. Do not use extension cords to
connect equipment to the surge protector.
4. Connected equipment can now be turned on.
5. Hold the surge protector firmly against wall when removing
plugs to prevent it from pulling loose.
USB Charging
• 1.0 Amp total output allows you to charge two smartphones
at full capacity at the same time. Recharge your device at a
maximum speed of 1.0 Amp when connected to a single port.
• The USB ports are used to charge portable electronic devices
only. There is no data transfer capability.
NOTE: Check the blue “PROTECTED” indicator light periodically. A glowing
blue indicator light shows that surge protection is being provided. If the blue
“PROTECTED” indicator light stops glowing, the surge protective components
have expired — though power will still be supplied to the outlets, now
unprotected. To ensure the protection of your electronics the surge protector
should be replaced.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free
of defects in workmanship and/or materials for the life* of the surge
protector. If such a defect should arise during the life of the surge
protector, Jasco Products Company will, at its option, either repair or
replace the surge protector without charge. This warranty does not
cover damage caused by lightning, accident, misuse or alterations to
the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan.
Even under normal circumstances and in the absence of defects,
the product’s life will expire when the surge protector’s component
capacity has been exceeded, thereby ceasing to provide protection
from surges. In this event, the Limited-Lifetime Warranty is no longer
valid and the surge protector should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return
the Jasco Products Company surge protector, freight prepaid, to
Jasco Products Company. Surge protectors returned to Jasco
Products Company must have an RA# included in the mailing
address to be accepted.
3. The original purchaser will be asked to send the surge protector,
a copy of the sales receipt for the product, your name, address,
phone number and a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 14521
Maximum Warranty Amount: $25,000 (USD)
NOTE: This device is not a lightning arrestor, so it will not afford
protection when lightning strikes nearby a power line, the house,
service entrance or antenna. The warranty is void if a power
disturbance damages your equipment through the coax, phone
or network lines.
Jasco Products Company will pay up to the maximum warranty
amount offered for the surge protector purchased to repair or
replace up to an amount equal to the fair market value or the
original purchase price, whichever is less, of your electronics
equipment, if damaged by a transient surge (except those caused by
direct lightning), within the life* of the surge protector, while properly
and directly connected to this surge protector. JASCO PRODUCTS
COMPANY DISCLAIMS AND ASSUMES NO LIABILITY FOR ANY OTHER
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT
NOT LIMITED TO, LOSS OR DAMAGE TO SOFTWARE OR DATA OR
DAMAGES OR COSTS ASSOCIATED WITH BUSINESS INTERRUPTION
OR OTHER DAMAGES DUE TO LOSS OR DAMAGE TO EQUIPMENT,
SOFTWARE OR DATA. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights that may
vary from state to state.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer’s warranty,
extended warranties, or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be safety certified by a Nationally
Recognized Testing Labortory.
2. The Jasco Products Company surge protector must be plugged
into properly wired and grounded outlets, no extension cords,
adapters, other ground wires, or electrical connectors may be
used, with the sole exception of other standard Jasco Products
Company 120 volt products approved for that use. The installation
must comply with all applicable electrical and safety codes set
forth pursuant to the National Electrical Code (NEC).
3. Any claim under the warranty policy must be made within 15 days
of the date of the alleged damage to the connected equipment.
For connected equipment coverage,
the following conditions must be satisfied:
A) All equipment eligible for warranty coverage must be plugged
directly into the Jasco Products Company surge protector.
Equipment connected to the protected equipment, but not
plugged directly into the surge protector will not be covered.
B) The equipment must have been damaged by a covered power
disturbance that passed through the Jasco Products Company
surge protector.
C) The Jasco Products Company surge protector must be damaged
from the power disturbance.
D) The Jasco Products Company surge protector’s protection
capacity must not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return
the Jasco Products Company surge protector, freight prepaid, to
Jasco Products Company. Surge protectors returned to Jasco
Products Company, Inc. must have an RA# included in the mailing
address to be accepted.
3. Jasco Products Company will determine whether the damage
to your equipment is covered by this warranty policy. If you are
covered, a claims adjuster will contact you and Jasco Products
Company will do one of the following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged
equipment.
d) Reimburse customer the initial purchase price of the damaged
equipment (customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether
the damage to the connected equipment is due to Jasco Products
Company surge protector failure by requesting that damaged
equipment be sent to Jasco Products Company for inspection.
FCC Statement
Notice: Federal Communications Commission (FCC)
requirements, Part 15
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
14521 V1
06/28/17
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Any changes of modifications not expressly approved by
the grantee of this device could void the users authority to operate the
equipment. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
MADE IN CHINA
GE is a trademark of General Electric Company and is under
license by Jasco Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime warranty.
Visit www.byjasco.com for warranty details.
Questions? Contact us at 1-800-654-8483
between 7:00AM—8:00PM CST.
RISK OF ELECTRIC SHOCK
• DO NOT USE IN WET LOCATIONS
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
• FULLY INSERT PLUG
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL RATINGS
NOT FOR USE WITH
• AQUARIUMS OR OTHER
WATER-RELATED PRODUCTS
• GENERATORS AND POWER INVERTERS
• MEDICAL LIFE-SUPPORT PRODUCTS
WARNING