Specification

Dimensions anD installation information
Dimension and installation information are shown in inches.
Listed by
Underwriters
Laboratories
PGP9830DJ/tJ
GE Profile
™
Series 30" Downdraft Gas Cooktop
Specification Created 2/15
InstallIng the ductWork: Use
galvanized or aluminum duct in 6" round
or 3-1/4" x 10" size, or combination of
both. PVC duct or locally approved piping
should be used if installing under a poured
concrete slab. Local building code must
be followed in specifying type and schedule
of all duct used.
note: Ductwork must be vented to
outside. Do not vent into a wall, ceiling,
crawlspace, attic or any concealed space.
Always use an appropriate roof or wall cap
with damper.
Laundry-type wall caps should never
be used. For maximum efficiency use the
shortest and straightest duct run possible,
with as few fittings as possible.
For satisfactory performance the duct
run should not exceed 100 feet equivalent
length. Refer to the table of equivalent
lengths (shown in installation instructions)
for various duct configurations.
Rear Wall VentingDownward Venting
Venting Options
Through Cabinet Toe Space
Inside Wall to Roof Direct to Outside
Between Floor Joist
9-1/8
10-1/8
18-3/4
6-1/8