Installation Guide

14
Installation Instructions
MAKING THE LP CONVERSION (CONT.)
3
CHANGE COOKTOP BURNER
ORIFICES
A
Remove the top grates,
burner caps, and burner
heads.
B
Remove the spark
igniters from the burner
base (if required to
access the orifices).
Using a No. 15 “Torx”
head driver bit, remove
the screws holding the
burner base in position.
C
Using a 7mm nut driver,
remove the top burner
orifices. These may be
accessed through the
hole in the cooktop.
Burner
cap
Burner
head
Burner
base
Spark igniter
Burner cap
Burner
head
Burner
base
Spark igniter
18,000 BTU Burner
(on some models)
3
CHANGE COOKTOP BURNER
ORIFICES (CONT.)
NOTE: On most burners,
the orifices have a spring-
loaded retaining ring around
the hex head to hold the
orifice in the nut driver during
installation and removal. A
slight amount of force is required to push the nut
driver down over the ring.
Remove This
Assembly
Orifice Spud Located
Through This Opening
Retainer
Ring