Quick Specs

PEB7227DL
GE Profile
™
Series 2.2 Cu. Ft. Built-In Sensor Microwave Oven
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
Listed by
Underwriters
Laboratories
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 4/18
ACCESSORY TRIM KITS FOR GE
MICROWAVE OVENS
(AVAILABLE AT ADDITIONAL COST)
For a custom built-in appearance, these kits
allow built-in installation of the microwave
oven into a wall or cabinet alone and are U.L.
approved for installation over a GE single
electric wall oven. These kits should not be
installed over a gas wall oven.
NOTE: 120V, 60-cycle, grounded power
receptacle location optional on back within
cabinet opening.
INSTALLATION INFORMATION: This
information is not intended to be used for
installing unit described. Before installing,
consult installation instructions packed with
product/kit for current dimensional data.
For ADA compliance, the microwave must be
installed no higher than 36 1/4".
Cabinet overlap requirements 30" 27"
A - Overlap of trim kit over top of cabinet 1" 1"
B - Overlap of trim kit over bottom of cabinet 1 1/8" 1 1/8"
C - Overlap of trim kit over sides of cabinet 2 1/8" 5/8"
Note:
Allow an additional inch
of clearance beyond trim
frame on all sides
Accessory Trim Kits Z Max Height Trim Kits
30" 29 3/4" 19" JX2130SLSS
27" 26 7/8" 19" JX2127SLSS
18 7/8"
Z
B
A
C
16 3/4" ± 1/8"
25 1/2" up to 25 5/8"
22" min.
receptacle
in cabinet
19-1/2" min.
receptacle
outside
cabinet
Base Pan
Trim
Kit
EXTERIOR DIMENSIONS (IN INCHES)
W x H x D 24 1/8" x 14" x 19 3/4"
ACCESSORY TRIM KITS “Z” MAX HEIGHT TRIM KITS
30" Deluxe 29 3/4" 18 7/8" JX7230DLWW/BB
27" Deluxe 26 7/8" 18 7/8" JX7227DLWW/BB