User Manual
49-1000464 Rev. 1 11
SIDE TANK ACCESSORY
Side Tank Accessory
NOTE:TherearetwodraintubeslocatedonthebackofyourOpalNuggetIceMakerindicatedasdraintubeAandB
in the illustration on page 12.
1.HandWashOnly:RinseandhandwashOpalSide
Tankwithwarmwaterandamilddishsoap.Remove
OpalSideTank’scapandwashthecapandrubber
valvewithwaterandamilddishsoap.TheSideTank
base can be washed by disconnecting the hose and 
addingasmallamountofsoapywatertoit.Scrubas
needed and rinse thoroughly. The rinse water should 
drain out the port in the back.
Rinsethecap,rubbervalve,tankandthebasewellto
remove any residual soap (see illustration). 
DO NOT WASH THE SIDE TANK IN THE 
DISHWASHER.
2.UnplugOpalNuggetIceMaker.UnhookOpal’sdrain
tubes and drain the water from the reservoir.
3.Connectdraintube,labeledB,tothebackofOpalSide
Tank’s base. 
4. Make sure drain tube (A) is connected to the black 
hanger and installed on the back of Opal.
5.Makesuredraintube(B)connectingtotheSideTank
isrestingflatonthecountertop.
SideTank
Cap and 
Valve
Unplugthis
draintube(B)
from the black 
hanger and 
connect this 
tube to the 
SideTank.
PlugdraintubeB
into the side tank 
here.
B A
TubeB 
attached to 
the side tank
TubeB 
attached to 
the side tank
6.PlaceOpalSideTankontherightorleft-handsideofthetheOpalNuggetIceMaker.Usingthesidetankattachment,
slide the shorter side of the attachment under the unit, near the front of the unit. The attachment will slide into a slot on 
thebottomoftheunit.Oncethisisplaced,thesidetankcanslideontotheoppositeattachment.Seeguresbelowand
onnextpage.
 NOTE: Care should be taken to connect the correct tube to the Opal Side Tank. Tube (B) should always be 
connected to the Side Tank whether it is installed on the left or right side of the Opal Nugget Ice Maker. It is 
important to make sure the tube is lying at, otherwise water may not ow from the side tank into the ice maker.










