Owner manual

Fact Sheet

Find a contact near you by visiting www.ge.com/water and clicking on “Contact Us”.

* Trademark of General Electric Company; may be registered in one or more countries.

FS1018EN.doc Aug-09

SeaPRO Series 50 Hz

Seawater Desalination Machines

45,000 ppm NaCl 500-1500 m

/day (100-300 gpm)

Basic Features (BAS)

• GE Fanuc Quick Panel 6-inch color display. Pri-

marily text operating screens, Touchscreen con-

trols.

• GE Fanuc Micro VersaMax processor

• 4-20 mA instruments displayed on instrument

center

• Variable frequency drive (VFD) for high pressure

pump

• Motor starter for boost pump

• Stand alone master control enclosure, skid

mounted local control enclosure with terminal

strips

• Membrane/energy recovery device (ERD)/boost

pump and pump/prefilter located on separate

skids

Premium Features (PRE)

• GE Fanuc QuickPanel 12-inch color display.

Text and pictorial operating screens. Touch-

screen controls.

• GE Fanuc VersaMax processor

• 4-20 mA instruments on touchscreen

• Primary and final pressure transmitters

• Variable frequency drive (VFD) for high pres-

sure pump

• Motor starter for boost pump

• Automated valves and control for feed flush

upon shut down

• Stand alone master control enclosure, local

control enclosure with remote I/O

• Membrane/energy recovery device

(ERD)/boost pump and pump/prefilter located

on separate skids

PAGE 1
Fact Sheet SeaPRO Series 50 Hz Seawater Desalination Machines 45,000 ppm NaCl 500-1500 m3/day (100-300 gpm) Basic Features (BAS) Premium Features (PRE) • GE Fanuc Quick Panel 6-inch color display. Primarily text operating screens, Touchscreen controls. • GE Fanuc QuickPanel 12-inch color display. Text and pictorial operating screens. Touchscreen controls.
PAGE 2
Operating Parameters Design Feed TDS Maximum Recovery Nominal Rejection Operating Temperature Minimum Inlet Pressure Design Temperature Materials of Construction 45,000 ppm NaCl 35% 95-98% 1.6 to 29.4ºC (35 to 85ºF) 2 Bar (30 psig) 25ºC (77ºF) Instrumentation Flow Meters........................Permeate, concentrate, low pressure (LP) ERD inlet, high pressure (HP) ERD outlet Conductivity.......................Permeate pH ...........................................Feed Pressure..............................
PAGE 3
MODEL SeaPRO-42 SeaPRO-63 SeaPRO-84 SeaPRO-126 Installation and Utility Requirements Inlet: Permeate: Concentrate: Inlet Water Pressure: Air Pressure: Drain to be Sized for: Power: Control Circuit: 4.0” flange 3.0” flange 3.0” flange 2 Bar, minimum 7 Bar, oil-free 1428 m3/day (261.9 gpm) 220/380 VAC, 3-phase, 50Hz 220 VAC, 1-phase, 50Hz 6.0” flange 3.0” flange 4.0” flange 2 Bar, minimum 7 Bar, oil-free 2,285 m3/day (419.2 gpm) 220/380 VAC, 3-phase, 50Hz 220 VAC, 1-phase, 50Hz 6.0” flange 3.