Manual

Page 2 FS1084EN 0702
Table 4: Integrity Testing
Table 5: Flow Performance in Clean Air
1
Table 6: Flow Performance in Clean Water
1
1
Data based on 10” length filter
Table 7: Ordering Information
Type Micron Rating Nominal Cartridge
Length
End #1 Adapter End #2 Adapter Elastomer Mate-
rial
MPM 91 = 0.1 µm
92 = 0.2 µm
1 = 10 in. (25.4 cm)
2 = 20 in. (50.8 cm)
3 = 30 in. (76 cm)
4 = 40 in. (101.5 cm)
A = Open End Gasket
B = 120 O-Ring
C = 213 O-Ring
E = 222 O-Ring
F = 226 O-Ring
J = 020 O-Ring
Q = 222 O-Ring
Stainless Steel Insert
Z = 226 O-Ring
Stainless Steel Insert
A = Open End Gasket
B = 120 O-Ring
C = 213 O-Ring
G = Closed End Cap
H = Fin Adapter
B = Buna-N
E = EPDM
S = Silicone
T = Teflon
2
Encapsulated
(Only in 222
and 226
Sizes
V = Viton
2
2
Teflon and Viton are registered trademarks of Dupont
Additional Information
• Memtrex PM filters may be autoclaved or in situ
steam sterilized (up to 253°F [123°C], 30 minute
cycles) for a maximum accumulated exposure
of 10 hours. Alternatively, the filters may be
sanitized with compatible chemical agents.
• GE certifies that the materials contained in its
Memtrex PM pleated filters meet U.S. FDA
requirements for food contact under the appli-
cable regulations in 21 CFR. For further informa-
tion, contact the GE technical services. Memtrex
PM filters meet the test criteria for USP class VI-
121°C Plastics.
• Aqueous extracts from Memtrex PM filters con-
tain less than 0.25 EU/ml. The filters typically
exhibit low levels of non-volatile residues. GE fil-
ter cartridges are designed and manufactured
for resistance to a wide range of chemical solu-
tions. Conditions will vary with each application
and users should carefully verify chemical com-
patibility. Please contact your GE distributor for
more information.
• Table 7 provides more information on ordering
Memtrex PM filters.