Spec sheet

MONOGRAM 36" BUILT-IN SIDE-BY-SIDE REFRIGERATOR ZISB360DK
Product Specification Revised 10/16
STANDARD
INSTALLATION
DISPENSER TRIM
RAISED OVERLAY PANEL DESIGN ON DISPENSER MODELS
1/4" PANEL DISPENSER TRIM 3/4" OVERLAY PANEL
DISPENSER TRIM
Freezer Door
1/4" Framed Panel
Ice/Water Dispenser
1/4"
Total
Thickness
Freezer Door
1/4" Backer Panel
.10" Spacer Panel
3/4" Overlay Panel
Ice/Water Dispenser
1.10"
Total
Thickness
A B
16 3/4"
10 5/8"
1/4" Backer Panel
3/4" Overlay Panel
.10" Spacer
1.10”
Total
Thickness
D
C
DISPENSER TRIM
NOTES
These refrigerators are supplied
with two dispenser trims, one for
framed panels and one for overlay
panels.
1/4" Panel Dispenser Trim:
The framed panel must be 1/4"
nominal thickness to fit the
dispenser trim.
• The dispenser trim ts over the
custom panel and snaps into the
freezer door.
• If the panel is less than 0.250"
thick, a noticeable gap may be
created around the dispenser
trim. Foam tape may be applied
on the door to improve the fit.
• If the panel is more than 0.250"
thick, the dispenser trim cannot
be secured to the door.
3/4" Overlay Panel Dispenser Trim:
The 3/4" overlay dispenser trim
is designed to fit a total panel
thickness of 1.100".
• If the panel is less than 1.100"
thick, a noticeable gap may be
created around the dispenser
trim.
• If the panel is more than 1.100"
thick, the dispenser trim cannot
be secured to the door.
• The overlay panel must be
constructed according to the
specifications shown to achieve
the correct total thickness.
• Alternative panel construction
methods such as securing a
3/4" panel to a 1/4" backer
panel cannot be used. Another
method, routing a 3/4"-thick
panel on all sides, cannot be
used. These methods will not
result in the required
1.100" panel thickness.
• When a raised panel design is to
be used, a custom middle rail is
required.
Raised Overlay Panel Design on
Dispenser Models:
When a raised panel design is to
be used, a custom wide middle
rail is required to accept the
dispenser trim.
• The middle rail must be
wide enough to allow for the
dispenser trim to overlap the
opening.
• The middle rail must be 1.10"
total thickness to accept the
dispenser trim.
SIDE VIEW CROSS SECTION
(SHOWING RAISED OVERLAY
WITH MIDDLE RAIL)