Spec sheet

MONOGRAM 36" BUILT-IN SIDE-BY-SIDE REFRIGERATOR ZISB360DK
Product Specification Revised 10/16
FLUSH INSET
INSTALLATION
NOTES
DISPENSER TRIM
RAISED PANEL DESIGN ON DISPENSER MODELS
16 3/4"
10 5/8"
DISPENSER TRIM
Freezer Door
3/4" Flush Panel
Ice/Water Dispenser
Freezer Door
1/4" Backer Panel
.10" Spacer Panel
1/2" Overlay Panel
Ice/Water Dispenser
.85"
Total
Thickness
3/4" OVERLAY PANEL
DISPENSER TRIM
1/2" OVERLAY PANEL
DISPENSER TRIM
A
SIDE VIEW CROSS SECTION
(SHOWING RAISED PANEL WITH
MIDDLE RAIL)
These refrigerators are supplied with
a dispenser trim for flush inset panels.
A
Panel Dispenser Trim:
The provided dispenser trim
is designed to fit a total panel
thickness of 3/4" or 0.85".
• If the panel is less than 3/4" thick,
a noticeable gap may be created
around the dispenser trim.
• If the panel is more than 0.85" thick,
the dispenser trim cannot be
secured to the door.
• The overlay panel must be
constructed according to the
specifications shown to achieve the
correct total thickness.
• When a raised panel design is to
be used, a custom middle rail is
required.
Raised Panel Design on
Dispenser Models:
When a raised panel design is to be
used, a custom wide middle rail is
required to accept the dispenser trim.
B
• The middle rail must be
wide enough to allow for the
dispenser trim to overlap the
opening.
C
• The middle rail must be 3/4"
total thickness for 3/4" panels
or 0.85" total thickness for 1/2"
panels to accept the dispenser
trim.
3/4" or 1/2" Flush Panel
3/4" or .85"
Total
Thickness
C
B