GE Monogram® Installation Instructions Beverage Center Model ZDB24 WW ZDB24 BB Wine Chiller Model ZDW24 WW ZDW24 BB www.monogram.
Important Information Beverage Center & Wine Chiller Before you begin—Read these instructions completely and carefully. IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference. CAUTION WARNING This appliance must be properly grounded. See “Electrical Supply”, page 4.
Design Information Beverage Center & Wine Chiller Models Available ZDB24 WW White Beverage Center ZDB24 BB Black Beverage Center ZDW24 WW White Wine Chiller The Monogram beverage center or the wine chiller adds an eloquent statement of style, convenience and flexibility. The Monogram beverage center and wine chiller can be used freestanding or as a built-in.
Installation Preparation Beverage Center & Wine Chiller Grounding the Beverage Center or Wine Chiller IMPORTANT - (Please read carefully) FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.
Installation Preparation Beverage Center & Wine Chiller Reverse Door Swing To remove the door: • Remove the top hinge pin using a 1/8" Allen wrench. Set aside. • Lift the door off the bottom hinge. • Remove the top hinge and set aside. • Remove the bottom hinge, the plastic washer and the bottom hinge pin using a Phillips screwdriver. • Install the Phillips hinge pin in the top hinge and re-install the top hinge on the bottom left side. • Re-install the plastic washer over the hinge pin.
Installation Beverage Center & Wine Chiller 1 Step Remove the Packaging Remove all packing material and tape. B. C. Tools and materials required: • #2 Phillips screwdriver Parts List: A. Stainless tubular handle B. 2 Handle standoffs C. 3 Screws for mounting handle standoffs (2 required, 1 extra) D. 3 Set screws (2 required, 1 extra) E. 3/32" Allen wrench for set screws F. 4 U-Clips G. 4 Leveling legs H. GE Monogram nameplate A. I. 8 Plug buttons J. Hinge Shims K. 2 Screws for light trigger hole D.
Installation Beverage Center & Wine Chiller 3 Step Install Leveling Legs • Tilt the unit slightly to one side to access the bottom corner holes. • Install a U-Clip into the front and rear holes on the bottom as shown. CAUTION: See illustration. Be sure the tangs on the clips are on the outside and the straight portion is inserted into the holes. • Screw the leveling legs into the U-clips all the way until snug. Then, adjust the leveling legs to installation height.
Template Beverage Center & Wine Chiller Template For Nameplate Location To be used when door swing has been reversed, with handle on right side, hinge on left side. To position new nameplate: • Remove the original nameplate, now located on the bottom of the door. • Cut template along dotted line. • Hold or tape template behind glass door in the upper left corner so that it is visible from the front side. • Remove backing from Monogram nameplate.
