DL 455a362e561c07b96069ab446b42

12
49-80152-7
Installation Instructions
67(3%$OWHUQDWH0RXQWLQJ0HWKRG
“A” Centerline
to Stud and
Keyhole Slots
“B” Hood
Width At
the Top
ZV48R 23-9/16" 47-15/16"
ZV48R 17-9/16" 35-15/16"
ZV36R 14-9/16" 29-15/16"
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING METHOD
When necessary, the hood may be installed so that it is
VXSSRUWHGE\WKHVRI¿W
7KHVRI¿WVKRXOGEHFRQVWUXFWHGZLWK[·V
• Determine the installation location on the wall.
• Continue the centerline forward on the bottom of the
FDELQHWRUVRI¿W
• The opening above the hood should allow for the 10"
round duct and clearance to slide the hood back against
the wall.
A
Requires 10-1/2" Min.
Opening For Ductwork
and Hood Installation
A
• The 2 x 4 studs must be located as shown in the chart,
Dim. A. to accept mounting screws.
,03257$176RI¿WIUDPLQJPXVWEHFDSDEOHRI
VXSSRUWLQJXSWROEV
• Drill 1/8" pilot holes into the studs at the locations shown
in the top view illustration.
Install Transition Onto Top of Hood
• Place the transition piece over the hood exhaust and
secure with 4 screws provided.
• Use duct tape to seal the connection. Check to be sure the
damper moves freely.
0RXQW+RRGRQWR6RI¿WRU&DELQHW
Note: If mounting to the underside of a cabinet with a
UHFHVVHGERWWRPLQVWDOOVKLPVWR¿OOWKHJDS
Duct
Transition
Top of
Hood
• Drive mounting screws into the studs until they protrude
1/4". The 1/4" gap will provide clearance to engage the
keyhole slots in the top of the hood.
• Lift hood to installation position. Locate house wiring and
route through the knockout (from the back or top of the
hood).
• Lift hood onto mounting screws. Slide back against the
rear wall.
• Tighten mounting screws.
IMPORTANT: For additional support and to minimize
vibration during operation, the hood must be secured
to the back wall. Use wall anchors to fasten bottom
back of hood to the wall.
2"
7-1/2"
A
C
B
2-9/16"
8"
8-1/8"
6"
Back of Hood
Top View
Front of Hood
IMPORTANT: Remove
shipping tape from
damper and check that
damper moves freely.
1/4" Gap
Push Back
to Wall
Add Shims
If Bottom
Is Recessed
Back
Wall
Soffit
Engage Top
Keyhole Slots