DL 455a362e561c07b96069ab446b42

10
49-80152-7
• Use a level to draw the cooktop centerline location. Draw
the line to ceiling height.
• Measure desired distance from the bottom of the hood
to the cooking surface.
Note: If you are installing the hood with duct covers, be sure to
read “Using Duct Cover Accessories” page 7. Exact installation
height may be determined by use of one or more duct covers.
• Determine bottom
of hood location
(Dimension A) by
subtracting 12-1/2"
from the desired
installation height.
• Use a level to draw
a straight horizontal
pencil line indicating
the bottom of the
hood.
• From the line indicating the bottom of the hood, measure
20" up and draw another line for the location of the
wood support. See illustration.
67(3'(7(50,1(+22''8&7:25.$1':,5,1*/2&$7,216
FOR VERTICAL (Straight Up) DUCTING:
• Use a level to draw a centerline from the bottom of the
KRRGWRFHLOLQJRUVRI¿W
• If venting out the ceiling, extend the centerline forward on
WKHFHLOLQJRUVRI¿W
• Locate the centerline of a 10-1/2" hole on the ceiling or
VRI¿WE\PHDVXULQJIURPWKHZDOO
FOR DUCTING THROUGH REAR WALL:
• Measure 9-7/8" above the marked line for the top of
the hood. At the centerline, mark location for a 10-1/2"
diameter hole.
House Wiring Location:
• The junction box is fastened to the back of the hood on
the right side.
Installation Instructions
Alternate Knockout Locations
If the installation requires, the junction box can be relocated
from the back to the top of the hood. Remove 3 screws,
align box to top knockout and secure with original screws.
• Remove junction box cover and knockout. Install strain
relief.
• The recessed back side of the hood provides a large area
for the house wiring to exit the wall and be routed to the
rear knockout and junction box.
• The location for the house wiring depends on the
installation height of the hood and the width of the hood.
• Remove junction box cover and knockout. Install strain
relief.
Dim. A
Installation
Height
*See recessed
location below.
Top of Hood
Bottom of Hood
22-1/2"
20"
Wood
Support
*House Wiring
Location
Dimension A
Cooking Surface
9-7/8"
14-1/4"
14" for 48" Models
8" for 36" Models
5" for 30" Models
Electrical
Area
6-1/2"
18-1/16" for 48" Models
12-1/16" for 36" Models
9-1/16" for 30" Models