Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
6 - 2 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
6
Section 1 General Information
A demo project, which is copied to the hard disk during the installation, is delivered in the same
package as PCS. Project DEMO_400 is for use with a C400 Controller. The demo provides an
overview of PANELWARE features.
Even if you do not have the PANELWARE hardware needed to execute the demo project, it will
still be useful to examine the demo to learn more about how to take advantage of PANELWARE’s
many features.
Project Name Directory Required Hardware
DEMO_400 Dest.path\USER\DEMO_400.PRD
The demo project is stored in this
directory after the installation.
PLC Hardware:
A GE Fanuc PLC
PANELWARE Hardware:
PANELWARE Panel with C400
Controller
See chapter 1 for an explanation of which GE Fanuc PLCs can be connected to a PANELWARE
Panel, using the C400 Controller.