Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
GFK-1115 4 - 1
Chapter
Configuring Communication with the PLC
This chapter provides information on how to configure the interfaces of the Panel Controller and
the PLC to make the connection between them. The following information is included:
■ Genius Protocol Parameters (Definition in PCS).........................................................4-2
❏ PLC Types...........................................................................................................4-3
❏ PLC Node Parameter Definitions.........................................................................4-5
❏ PLC Network Parameter Definitions....................................................................4-7
■ SNP 90 Protocol Parameters (Definition in PCS)........................................................4-9
■ Settings on the Panel ................................................................................................4-10
■ Panel Interface..........................................................................................................4-10
■ Configuration of the PLC Interface...........................................................................4-10
❏ Genius...............................................................................................................4-11
❏ SNP...................................................................................................................4-11
4