Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
GFK-1115 Chapter 3 Quick Start 3 - 39
3
Picture List Organization
When you press the F3 Picture List function key from the Edit Project window, a list of all of
the pictures that are bound to the project is displayed:
The picture defined as the ERROR picture is not allowed to be placed in the top position in the
picture list; the picture in the top position must be the one initially displayed when the Panel is
power cycled (start-up picture).
Accordingly, in this example, the ERROR picture must be moved down from its top position in
the list using the F7 Back function key. This will move the item in the current cursor position
down one line in the list, and move the next item one line up as shown below:
The START-UP picture should now be in the correct position (000).
Press the F10 Exit function key to save the changes and redisplay the Edit Project window. Press
F10 Exit again to return to the Main menu.