Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
GFK-1115 Chapter 3 Quick Start 3 - 31
3
The definition that is entered can be saved by pressing the F4 Accept function key. Once saved,
the newly selected variable is shown in the VAT.
Pressing the F10 Exit function key causes the connection list to appear on the screen again.
Genius Internal Connection
Select the GE Genius Internal connection from the connection list and press either F5 VAT or ↵↵
to display the connection in the Variable Assignment Table:
Press the F1 Edit function key to open the VAT Definition window for the GENIUS_BUS
tagname. Edit the definition for GENIUS_BUS as shown below (Follow the same procedure that
was used for editing the tagname VALUE1 in the DD connection
— see page 30):
After accepting the entry (by pressing F4), press F10 Exit to return to the Connection List
window.