Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
3 - 24 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
3
Press the F2 Field function key to open the Field Class selection window.
Select the Output Field entry from the list and press ↵↵ to access the Select Field Type window.
Several output field types can be chosen from this widow:
For this example, select the Output Word (signed) field type. This results in a data entry form
(with default entries) being opened on the screen.
In the Output Word window, change the following entries as shown by highlighting them using
the cursor keys, then typing the new text:
Places after dec. point:
2
Tagname:
VALUE1
Note
To complete an entry, you must press ↵↵. If you change an entry and then press a
cursor key instead, your entry will be ignored and the previous contents of the
entry will be restored.
VALUE1 is a symbolic name for a memory location in the PLC. Assigning symbolic names to the
actual PLC addresses is accomplished using the connection editor.
Press the F4 Accept function key to close the field and confirm it as part of the picture. The field
should be displayed within the picture: