Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
GFK-1115 Appendix B Errors/Troubleshooting B - 5
B
Error! Error picture and first picture cannot be the same!
The compilation of a project is interrupted with this error message if the error picture is defined in
the first position of the picture directory. The start-up picture must be listed in the first position of
the directory (see the Chapter 2, “Quick Start” section entitled “Binding Pictures in a Project”).
Cannot make connection with panel!
Please check cable and installation!
After calling the Download function, this message appears if the connection to the panel cannot be
made. Check that the following conditions are met:
■ Is the PC connected to the panel?
■ Is the panel properly supplied with power?
■ Are all cables connected to the proper interfaces?
-IF0 on the panel
-COM1 or COM2 on the PC, depending on the PCS configuration (see "PCS
Configuration" in chapter 3)
■ Is the panel in Teach Mode?
■ Is the download cable in good shape and properly connected?